Click
on any of the pictures below to see a larger version. |
 |
| |
|
This cockpit audio system upgrade sets six silver speaker grills in red bolsters which precisely matches the factory vinyl accents. Red hot lighting was added in the cockpit and exterior vents.
. |
| |
|
|
Within the cabin an amplifier shroud covered in a graphite vinyl with a carbon fiber pattern, conceals all wiring. |
| |
|
|
 At the front of the cockpit, Polk Audio coaxils are doubled up for greater output. This is an essential component in the design of a performance boat system. On the starboard side, the speakers are set in a red vinyl clad bolster. The port side features an angled fiberglass pod to offset the coaming angle.
|
| |
|
|
 A pair of rear Polks are loaded into red bolster rings. Each 6 ½ - inch speaker is trimmed in an LED light ring. The acrylic diffusers are partially recessed into the bolster rings.
Variable-angle tweeters in Polk Audio coaxils allow for optimum aiming. |
| |
|
|
 Twin free-air 10-inch subwoofers are loaded into the rear bench seat console. From the console inteior, resin-coated and painted birch baffle rings reinforce the mounting. The asymmetrical position compound loads the dual woofers in the corner, which effectively doubles their output. Location matters. And this system hammers! |
| |
|
|
| Six frosted acrylic diffuser rings contain 33 red diodes each. |
|
|
|
|
| Three red step lights across the back of the cockpit.
|
|
|
| |
 |
Concealed within the engine compartment vents are fiery red LED strips in clear watertight tubes.
|
| |
| |
| Earmark Car Audio ©2004 Earmark Car Audio. All Rights Reserved. Design & Programming
by Ad
Cetera Inc. |
